Hyundai Palisade (LX2): Brake System
- Specifications
- Special service tools
- Troubleshooting
- Brake bleeding procedures
- Brake System
- Repair procedures
- Brake Booster
- Master Cylinder
- Brake Line
- Brake oil
- Brake Pedal
- Front Disc Brake
- Rear Disc Brake
- Brake Pad
- Stop Lamp Switch
- Parking Brake System
- ESP(Electronic Stability Program) System
- Components and components location
- Description and operation
- Schematic diagrams
- Troubleshooting
- ESP Control Module
- ESP OFF Switch
- Front Wheel Speed Sensor
- Rear Wheel Speed Sensor
- Emergency Signal System
- Yaw-rate and G Sensor
- Downhill Brake Control Switch
- Steering Angle Sensor
- Forward Collision-Avoidance Assist (FCA) System
Components and components location Components 1. Front Seat Belt Pretensioner (BPT) Description and operation Description The Seat Belt Pretensioners (BPT) are installed inside center pillar (LH & RH).
Specifications Item Specification Master cylinder • Type • I.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: A/C Pressure Transducer
Description and operation Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Cluster Ionizer
Description and operation Description The cluster ionizer makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When the ignition switch is ON, the ionizer runs "CLEAN" mode and then "ION" mode, switching between both modes.
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Resetting the Driver's Seat Memory System
- Body (Interior and Exterior)
- Brake bleeding procedures
- New on site
- Most important about car
