Hyundai Palisade: Interior features / Power Outlet

■ Front

■ Rear (2nd row)

■ Center console storage

■ Rear (3rd row, left side)
The power outlet is designed to provide
power for mobile telephones or
other devices designed to operate
with vehicle electrical systems. The
devices should draw less than 180 W
with the engine running.
WARNING
Avoid electrical shocks. Do not
place your fingers or foreign
objects (pin, etc.) into a power
outlet or touch the power outlet
with a wet hand.
NOTICE
To prevent damage to the Power
Outlets :
- Use the power outlet only when
the engine is running and
remove the accessory plug after
use. Using the accessory plug
for prolonged periods of time
with the engine off could cause
the battery to discharge.
- Only use 12V electric accessories
which are less than 180 W
in electric capacity.
- Adjust the air-conditioner or
heater to the lowest operating
level when using the power outlet.
- Close the cover when not in use.
- Some electronic devices can
cause electronic interference
when plugged into a vehicle's
power outlet.These devices may
cause excessive audio static
and malfunctions in other electronic
systems or devices used
in your vehicle.
- Push the plug in as far as it will
go. If good contact is not made,
the plug may overheat and the
fuse may open.
- Plug in battery equipped electrical/
electronic devices with
reverse current protection. The
current from the battery may
flow into the vehicle's electrical/
electronic system and cause
system malfunction.
Conversation mirror
You can see widely the rear view
through the conversation mirror.
To open:
Press the cover and the holder will
slowly open.
To close:
Push back into position...
The AC inverter supplies 115V/150W
electric power to operate electric
accessories or equipments.
Information
Rated voltage : AC 115V
Maximum electric power : 150W
In order to avoid an electrical system
failure, electric shock, etc...
Other information:
Components and components location
Components
1. Front seat heater switch
2. Rear seat heater switch
Schematic diagrams
Circuit Diagram
Front Seat
No
Connector A
1
C_CAN (High)
2
C_CAN (Low)
3
-
4
LIN
5
-
6
Auto hold signal
7
-
8
Battery (+)
9
IGN
10
Illumination (+)
11
-
12
Illumination (-)
13
Ground
14
DETENT
15
-
16
PDW signal
17
Steering wheel heater signal
18
DBC signal
19
ISG signal
20
SVM/RVM signal
21
ISG indicator
22
SVM indicator
23
PDW indicator
24
Steering whell heater indicator
2nd Seat
No
Connector A
1
Battery (+)
2
ISG Power(+)
3
Illumination (+)
4
Sensor REF (+5V)
5
Mode actuator feadback
6
Temperature actuator feedback
7
Mode actuator (Vent)
8
Mode actuator (Defrost)
9
Temperature actuator (Cooling)
10
Temperature actuator (Heating)
11
DETENT (-)
12
K-LINE
13
LIN line (Rear left seat)
14
LIN line (Rear right seat
15
-
16
Illumination (-)
17
IGN 2
18
IGN 1
19
Blower motor (+)
20
-
21
Rear FET (Drain feedback)
22
Rear FET (Gate)
23
Left heater swtich
24
Left heater indicator (High)
25
Left heater indicator (Middle)
26
Left heater indicator (Low)
27
Right heater swtich
28
Right heater indicator (High)
29
Right heater indicator (Middle)
30
Right heater indicator (Low)
31
Sensor ground
32
Ground
Repair procedures
Removal
Front seat
1...
Components and components location
Components
1. Warning indicator
2. SVM camera
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2...
Categories

If the remote key is not working properly,
try replacing the battery with a
new one.
Battery Type: CR2032
To replace the battery:
read more