Hyundai Palisade (LX2): Brake System / ESP(Electronic Stability Program) System
- Components and components location
- Description and operation
- Schematic diagrams
- Troubleshooting
- ESP Control Module
- ESP OFF Switch
- Front Wheel Speed Sensor
- Rear Wheel Speed Sensor
- Emergency Signal System
- Yaw-rate and G Sensor
- Downhill Brake Control Switch
- Steering Angle Sensor
Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
Components 1. ABS control module (HECU) 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. ABS warning lamp 5.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Antenna Coil
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Mode Control Actuator
Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Body (Interior and Exterior)
- Power Outlet
- Engine Electrical System
- New on site
- Most important about car
