Hyundai Palisade (LX2): Heating,Ventilation And Air Conditioning / Rear Heater
- Rear Heater Unit
- Rear Heater Core
- Rear Evaporator Core
- Rear Blower Motor
- Rear Temperature Control Actuator
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit.
Components and components location Component Location 1. Rear Heater & A/C Unit Repair procedures Replacement • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Power Mosfet (DATC)
Repair procedures Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures
Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of around view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Body (Interior and Exterior)
- General Tightening Torque Table
- Automatic Transaxle Fluid (ATF)
- New on site
- Most important about car
