Hyundai Palisade (LX2): Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly
- Hood Insulator Pad
- Hood Lift
- Hood Weatherstrip
- Hood Latch Release Handle
- Hood Latch
Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components • Put on gloves to prevent hand injuries 1.
Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Compressor
Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Rear Blower Motor
Repair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear blower motor connector (A), loosen the mounting screws and remov
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Removing and Storing the Spare Tire
- Rear Bumper Cover
- Automatic Transaxle Fluid (ATF)
- New on site
- Most important about car
