Hyundai Palisade (LX2): Lubrication System / Oil Filter Body

Components and components location

Components

Hyundai Palisade. Components and components location

1. Oil fliter body
2. Gasket

Repair procedures

Removal
Hyundai Palisade. Repair procedures   
•
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
1.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
2.
Drain the engine oil.
(Refer to Lubrication System - "Engine Oil")
3.
Remove the oil filter body (A).
Tightening torque :
19.6 - 21.6 N.m (2.0 - 2.2 kgf.m, 14.5 - 15.9 lb.ft)

Hyundai Palisade. Repair procedures

4.
Install in the reverse order of removal

    Repair procedures Replacement    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Components and components location Components 1. Lower oil pan 2. Upper oil pan Repair procedures Removal    • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Blower Motor

    Repair procedures Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Rear Evaporator Core

    Repair procedures Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2. Loosen the mounting screws, remove the rear heater & A/C unit cover (A) and evaporator core (B).

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0133