Hyundai Palisade (LX2): General Information / Lift and Support Points

General information

Lift and Support Points
Hyundai Palisade. Lift and Support Points   
•
When raising the vehicle with a two-post car lift to service the bottom of the vehicle, check the vehicle bottom and make sure not to damage the floor under cover, fuel tank, fuel filter and canister.
Hyundai Palisade. Lift and Support Points   
•
Since each tire/wheel assembly weights approximately 30lbs (14kg), placing the front wheels in the luggage area can assist with the weight distribution.
•
Use the same support points to support the vehicle on safety stands.
[Two-Post Car Lift]
1.
Place the lift blocks under the support points as shown in the illustration.
2.
Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.
3.
Raise the hoist to full height to inspect the lift points for secure support.

Hyundai Palisade. Lift and Support Points

Hyundai Palisade. Lift and Support Points

[Four-Post Car Lift]
1.
Position the lift aligned with the side seal of the vehicle bottom.
2.
Raise the hoist to full height to check whether the vehicle is firmly supported.

Hyundai Palisade. Lift and Support Points

[Scissor Car Lift]
1.
Place the vehicle on the lower side of the lift body.
Hyundai Palisade. Lift and Support Points   
•
When raising the vehicle with a scissor car lift to service the bottom of the vehicle, check the vehicle bottom and make sure not to damage the floor under cover, fuel tank, fuel filter and canister. Also, use a rubber support or stanchion on the side seal of the vehicle body.
2.
Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported.
3.
Raise the hoist to full height to inspect the lift points for secure support.

Hyundai Palisade. Lift and Support Points

    General information Warning and Caution Labels 1. Radiator cap caution 2. Fan caution 3. Battery caution Battery Caution Label Warning / Caution Label (Cont'd) A.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Refrigerant Line

    Components and components location Components [Isometric view] 1. Front suction & Liquid pipe assembly [Top view] 1. Front suction & Liquid pipe assembly Repair procedures Replacement [Front suction & Liquid pipe assem

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0116