Description and operation Description The ICM relay is united with (rear wiper relay, seat heater relay(front/rear), head lamp washer relay and rear A/C relay) which installed inside the lower crash pad.
Components 3.5 Inch MONO LCD 7 Inch TFT LCD Connector Pin Information No Connector A No Connector B 1 Ground 21 Trip switch (-) 2 Illumination (-) 22 Trip switch 1 (+) 3 Rheostat switch (Down)_Input 23 Trip switch 2 (+) 4 Rheostat switch (Up)_Input 24 Active ECO_input switch/ R switch(M/T)_input 5 Dentent 25 Driver mode switch/ N switch(M/T)_input 6 - 26 Speaker1 (+)_Output 7 - 27 Speaker1 (-)_Output 8 - 28 - 9 - 29 B-CAN (Low) 10 - 30 B-CAN (High) 11 - 31 Engine Run State_Output 12 Vehicle speed_Output 32 C-CAN (High) 13 Alternator_Input 33 C-CAN (Low) 14 Fuel sender (+)_Input 34 Temperature_Input 15 - 35 - 16 Fuel sender (-)_Input 36 Steering wheel heater indicator 17 Water separate_Input 37 Ground 18 Airbag (+)_Input 38 - 19 Oil press switch (-)_Input 39 IGN 1 20 - 40 Battery (+)
Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of around view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.
Components and components location Components [Ultra Optical Camera - RH/LH] [Ultra Optical Camera - Front] [Ultra Optical Camera - Rear] Repair procedures Removal • In case of bad quality or poor