Hyundai Palisade (LX2): Indicators And Gauges / Troubleshooting

Hyundai Palisade (LX2) 2020-2026 Service Manual / Body Electrical System / Indicators And Gauges / Troubleshooting

Troubleshooting
Symptom
Possible cause
Remedy
Speedometer does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Speedometer faulty
 Check speedometer
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Tachometer does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Tachometer faulty
 Check tachometer
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Fuel gauge does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Fuel gauge faulty
 Check gauge
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Low fuel warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Water temperature gauge does not
operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Water temperature gauge faulty
 Check gauge
Water temperature sender faulty
 Check sender
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Oil pressure warning lamp does not
light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Oil pressure switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Parking brake warning lamp does not
light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Brake fluid level warning switch faulty
 Check switch
Parking brake switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Open door warning lamp and tailgate
warning lamp do not light up
 Memory fuse (15A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Door switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Seat belt warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Seat belt switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Speedometer and odometer does not
operate
 CAN line faulty
 Check the ABS ECU
Wheel speed sensor faulty
 Check the wheel speed sensor

    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A).

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until it reaches high speed.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright В© 2026 www.hpalisadelx.com - 0.013