Hyundai Palisade (LX2): Driving Your Vehicle / Forward Collision-Avoidance Assist (FCA) system

Hyundai Palisade (LX2) 2020-2026 Owner's Manual / Driving Your Vehicle / Forward Collision-Avoidance Assist (FCA) system

The Forward Collision-Avoidance Assist (FCA) system is designed to help detect and monitor the vehicle ahead or help detect a pedestrian in the roadway through radar signals and camera recognition to warn the driver that a collision is imminent, and if necessary, apply emergency braking.

WARNING

Take the following precautions when using the Forward Collision- Avoidance Assist (FCA) system:

  • This system is only a supplemental system and it is not intended to, nor does it replace the need for extreme care and attention of the driver. The sensing range and objects detectable by the sensors are limited. Pay attention to the road conditions at all times.
  • Drive at posted speed limits and accordance to road conditions.
  • Always drive cautiously to prevent unexpected and sudden situations from occurring. The Forward Collision- Avoidance system may not always stop the vehicle completely and is only intended to help mitigate a collision that is imminent.

The drive mode may be selected according to the driver's preference or road condition. Drive Mode The mode changes whenever the DRIVE MODE selection knob is rotated.

System setting • Setting Forward Safety function The driver can activate the FCA by placing the ignition switch to the ON position and by selecting: 'User Settings →Driver Assistance → Forward Safety' - If you select "Active Assist", the FCA system activates.

Other information:

Hyundai Palisade (LX2) 2020-2026 Service Manual: Compressor oil

Repair procedures Oil Specification 1. The R-134a or R-1234yf system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2.

Hyundai Palisade (LX2) 2020-2026 Service Manual: Rear Temperature Control Actuator

Repair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear temperature actuator connector (A), loosen the mounting screws a

Categories

 
Copyright © 2026 www.hpalisadelx.com - 0.013