Hyundai Palisade: Hood / Hood Insulator Pad
Repair procedures
1. |
Using a clip remover, remove the clips and then the hood insulator pad
(A).
•
|
Be careful not to scratch the hood panel.
|
|

|
2. |
To install, reverse removal procedure.
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Component Location
1. Hood assembly
Repair procedures
Replacement
•
Be careful not to damage the hood and body...
Repair procedures
Replacement
•
When removing and installing the hood lifter, an assistant is
necessary...
Other information:
Components and components location
Components
[LH]
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Shaft
6. TJ boot band
7. TJ boot
8. Spider assembly
9...
The LKA system may operate prematurely
even if the vehicle does not
depart from the intended lane, OR,
the LKA system may not warn you if
the vehicle leaves the intended lane
under the following circumstances:
When the lane and road conditions
are poor
It is difficult to distinguish the lane
marker from the road because the
lane marker is covered with dust or
sand...
Categories
The front seat can be adjusted by
using the levers located on the outside
of the seat cushion. Before driving,
adjust the seat to the proper
position so that you can easily control
the steering wheel, foot pedals
and controls on the instrument
panel.

read more