Hyundai Palisade (LX2): Lighting System / Hazard Lamp Switch
Repair procedures
| Removal |
| 1. |
Disconnct the negative (-) battery terminal.
|
| 2. |
Remove the audio/AVN keyboard assembly.
(Refer to Audio - "Audio Keyboard Assembly")
(Refer to AVN System - "AVN Keyboard Assembly")
|
| Installation |
| 1. |
Install the audio/AVN keyboard assembly.
|
| 2. |
Connect the negative (-) battery terminal.
|
Schematic diagrams Circuit Diagram Repair procedures Inspection 1. Remove the overhead console lamp connector (A) then check for continuity between terminals.
Components and components location Components Repair procedures Inspection Rheostat Switch 1. Disconnect the negative (-) battery terminal.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Intake Actuator
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation
Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- PTG Spindle
- Troubleshooting
- Emergency liftgate safety release
- New on site
- Most important about car
