Hyundai Palisade (LX2): Instrument cluster / Warning and Indicator Lights
Information
Make sure that all warning lights are OFF after starting the engine. If any light is still ON, this indicates a situation that needs attention.
- Seat Belt Warning Light, Air Bag Warning Light, Parking Brake & Brake Fluid Warning Light
- Anti-lock Brake System (ABS) Warning Light, Electronic Brake Force Distribution (EBD) System Warning Light
- Electric Power Steering (EPS) Warning Light, Malfunction Indicator Lamp (MIL), Electronic Parking Brake (EPB) Warning Light
- Charging System Warning Light, Engine Oil Pressure Warning Light, Low Fuel Level Warning Light
- Washer Fluid Warning Light, Master Warning Light, Low Tire Pressure Warning Light
- All Wheel Drive (AWD) Warning Light, Forward Collision- Avoidance Assist (FCA) System Warning Light, Lane Keeping Assist (LKA) System Indicator Light
- LED Headlight Warning Light, Icy Road Warning Light, AUTO STOP Indicator Light
- Electronic Stability Control (ESC) Indicator Light, Electronic Stability Control (ESC) OFF Indicator Light
- Immobilizer Indicator Light
- Turn Signal, High Beam, High Beam Indicator Lights
- High Beam Assist (HBA), AUTO HOLD, Cruise, SPORT Mode indicator lights
- SMART Mode, All Wheel Drive LOCK, Downhill Brake Control (DBC) Indicator Lights
Automatic transmission shift indicator This indicator displays the gear position of the shift button. â– Type A â– Type B Shift indicator pop-up (if equipped) The pop-up indicates the current gear position displayed in the cluster for about 2 seconds when shifting into other positions (P/R/N/D).
Seat Belt Warning Light This warning light informs the driver that the seat belt is not fastened. Air Bag Warning Light This warning light illuminates: When you set the ignition switch or the Engine Start/Stop button to the ON position.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures
Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Intake Actuator
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Electrochromatic Mirror (ECM) with homelink system
- Engine Mechanical System
- Rear Heater Unit
- New on site
- Most important about car
