Hyundai Palisade (LX2): Warning and Indicator Lights / Turn Signal, High Beam, High Beam Indicator Lights
Turn Signal Indicator Light
This indicator light blinks:
• When you operate the turn signal indicator stalk.
If any of the following occur, there may be a malfunction with the turn signal system.
- The turn signal indicator light illuminates
but does not blink
- The turn signal indicator light blinks
rapidly
- The turn signal indicator light does
not illuminate at all
If any of these conditions occur, have your vehicle inspected by an authorized HYUNDAI dealer.
High Beam Indicator Light
This indicator light illuminates:
- When the headlights are on and in the high beam position
- When the turn signal lever is pulled into the Flash-to-Pass position.
Light ON Indicator Light
This indicator light illuminates:
- When the tail lights or headlights are on.
Immobilizer Indicator Light (without smart key) This indicator light illuminates: • When the vehicle detects the immobilizer in the key with the ignition switch in the ON position.
High Beam Assist (HBA) indicator light This indicator light illuminates : When the high-beam is on with the light switch in the AUTO light position.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Blower Motor
Repair procedures Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear mode actuator connector (A), loosen the mounting screws and remove the rear mode ac
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Engine Mechanical System
- Emergency liftgate safety release
- Body Electrical System
- New on site
- Most important about car
