Electric Power Steering (EPS) Warning Light

This warning light illuminates:
Malfunction Indicator Lamp (MIL)

This indicator light illuminates:
• When you set the ignition switch or the Engine Start/Stop button to the ON position.
- The malfunction indicator light illuminates for about 3 seconds and then goes off.
• Whenever there is a malfunction with either the emission control system or the engine or the vehicle powertrain.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
NOTICE
Driving with the Malfunction Indicator Lamp (MIL) on may cause damage to the emission control system which could affect drivability and/or fuel economy.
NOTICE
If the Malfunction Indicator Lamp (MIL) illuminates, potential catalytic converter damage is possible which could result in loss of engine power.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.
Electronic Parking Brake (EPB) Warning Light

This warning light illuminates:
• When you set the ignition switch or the Engine Start/Stop button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
• When there is a malfunction with the EPB.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer.
Information
The Electronic Parking Brake (EPB) Warning Light may illuminate when the Electronic Stability control (ESC) Indicator Light comes on to indicate that the ESC is not working properly (This does not indicate malfunction of the EPB).
Anti-lock Brake System (ABS) Warning Light This warning light illuminates: When you set the ignition switch or the Engine Start/Stop button to the ON position.
Charging System Warning Light When this warning light illuminates while the engine is running, the battery is not being charged. Immediately turn OFF all electrical accessories.
Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →