Washer Fluid Warning Light

This warning light illuminates:
• When the washer fluid level in the reservoir is nearly empty.
If washer fluid warning light illuminates, refill the washer fluid reservoir in the engine room when possible.
Master Warning Light

This warning light illuminates:
• When there is a malfunction in operation in any of the following systems:
- LED headlamp malfunction
(if equipped)
- Forward Collision-Avoidance
Assist system malfunction
(if equipped)
- Forward Collision-Avoidance
Assist radar blocked (if equipped)
- Blind-Spot Collision Warning
system malfunction (if equipped)
- Blind-Spot Collision Warning
radar blocked (if equipped)
- Smart Cruise Control with Stop
& Go malfunction (if equipped)
- Smart Cruise Control with Stop
& Go radar blocked (if equipped)
- Lamp malfunction
- High Beam Assist malfunction
(if equipped)
- Tire Pressure Monitoring System
(TPMS) malfunction
To identify the details of the warning, look at the LCD display.
Low Tire Pressure Warning Light

This warning light illuminates:
This warning light remains ON after blinking for approximately 60 seconds, or repeatedly blinks ON and OFF in 3 second intervals:
• When there is a malfunction with the TPMS.
If this occurs, have the vehicle inspected by an authorized HYUNDAI dealer as soon as possible.
WARNING
Safe Stopping
Charging System Warning Light When this warning light illuminates while the engine is running, the battery is not being charged. Immediately turn OFF all electrical accessories.
All Wheel Drive (AWD) Warning Light This warning light illuminates: When you set the ignition switch or the Engine Start/Stop button to the ON position.
Repair procedures Oil Specification 1. The R-134a or R-1234yf system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2.
Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of around view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.