Hyundai Palisade (LX2): Sunroof / Tilting the Sunroof (Front)

Hyundai Palisade. Tilting the Sunroof (Front)

Tilt the sunroof open:

Push the sunroof control lever upward until the sunroof moves to the desired position.

To close the sunroof:

Push the sunroof control lever forward until the sunroof closes.

Automatic reverse

Hyundai Palisade. Tilting the Sunroof (Front)

If the sunroof senses any to an obstacle while it is closing automatically, it will reverse direction then stop to allow the object to be cleared.

WARNING

Small objects that can get caught between the sunroof glass and the front glass channel may not be detected by the automatic reverse system. In this case, the sunroof glass will not detect the object and will not reverse direction.

NOTICE

  • Periodically remove any dirt that may accumulate on the sunroof guide rail or between the sunroof and roof panel which can make a noise.
  • Do not try to open the sunroof when the temperature is below freezing or when the sunroof is covered with snow or ice, otherwise the motor could be damaged. In cold and wet climates, the sunroof may not work properly.

    Sunroof Opening and Closing To open: Press the sunroof control lever backward to the first detent position. Release the switch when you want the sunroof to stop.

    â–  Front â–  Rear The sunroof may need to be reset if the following conditions occur: The battery is discharged or disconnected or the sunroof fuse has been replaced or disconnected The sunroof control lever is not operating correctly To reset the sunroof, perform the following steps: 1.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Troubleshooting

    Troubleshooting Problem Symptoms Table Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor. Use the table below to help you find the cause of the problem.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Evaporator Temperature Sensor

    Description and operation Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. Repair procedures Inspection 1.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0109