Hyundai Palisade: Body Side Molding / Rear Spoiler

Hyundai Palisade (LX2) 2020-2025 Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Spoiler

Components and components location

Component Location

Hyundai Palisade. Components and components location

1. Rear spoiler

Repair procedures

Replacement

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

1.	Remove the tailgate upper trim. (Refer to Tailgate - "Tailgate Trim")

2.	Remove the rear spoiler plug hole (A) and loosen the mounting nuts. [LH] [RH]

3.	Separate the rear stop lamp connector (A) and rear washer nozzle (B).

Loosen the mounting nuts and remove the rear spoiler (A).

Tightening torque :

2.9 - 3.9 N.m (0.3 - 0.4 kgf.m, 2.2 - 2.9 lb-ft)

Hyundai Palisade. Repair procedures

To install, reverse removal procedure.

•	Make sure the connector is connected properly.

•	Replace any damaged clips (or pin-type retainers).

Body Side Molding

Fender Garnish

Repair procedures Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Other information:

Hyundai Palisade (LX2) 2020-2025 Service Manual: Front Oil Seal

Repair procedures Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift...

Hyundai Palisade (LX2) 2020-2025 Service Manual: Repair procedures

Component Replacement after Deployment • Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs...