Hyundai Palisade (LX2): Air conditioning System / Compressor oil

Hyundai Palisade (LX2) 2020-2026 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor oil

Repair procedures

Oil Specification
1.
The R-134a or R-1234yf system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.
2.
Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
Handling of Oil
1.
The oil should be free from moisture, dust, metal powder, etc.
2.
Do not mix with other oil.
3.
The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (R-134a or R-1234yf Compressor Oil absorbs moisture very easily.)
4.
The compressor oil must be stored in steel containers, not in plastic containers.
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system :
PAG 30 : 180 ± 10cc (6.3 ± 0.3oz.)
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows :
1.
Open all the doors and engine hood.
2.
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.
3.
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.
4.
Stop the engine.

    Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.

    Components and components location Components [Isometric view] 1. Front suction & Liquid pipe assembly [Top view] 1.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: A/C Pressure Transducer

    Description and operation Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation

    Description Blind-Spot Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0165