Hyundai Palisade (LX2): Surround View Monitor (SVM) / Surround View Monitor (SVM) Camera

Hyundai Palisade (LX2) 2020-2026 Service Manual / Advanced Driver Assistance System (ADAS) / Surround View Monitor (SVM) / Surround View Monitor (SVM) Camera

Components and components location

Components
[Ultra Optical Camera - RH/LH]

Hyundai Palisade. Components and components location

[Ultra Optical Camera - Front]

Hyundai Palisade. Components and components location

[Ultra Optical Camera - Rear]

Hyundai Palisade. Components and components location

Repair procedures

Removal
Hyundai Palisade. Repair procedures   
•
In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.
SVM Front Camera
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
3.
Disconnect the front camera connector (A), loosen the mounting screws and remove the front camera.

Hyundai Palisade. Repair procedures
SVM Rear Camera
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
3.
Remove the tailgate back panel.
(Refer to Body - "Tailgate Back Panel")
4.
Disconnect the camera connector (A) and remove the rear view camera after loosening mounting screws.

Hyundai Palisade. Repair procedures
Left/ Right Camera
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mirror.
(Refer to Body - "Outside Rear View Mirror")
Installation
1.
To install, reverse the removal procedure.

    Components and components location Components No Connector A 1 ACC 2 LED 3 EXT Ground 4 Y Shield 5 - 6 C-CAN Low 7 Y Video ground 8 - 9 - 10 Rear camera power 11 Left camera power 12 Right camera power 13 Ignition 14 AVM switch 15 - 16 C Shield 17 - 18 C- CAN High 19 C video ground 20 C video output 21 - 22 - 23 Left camera ground 24 Right camera ground Repair procedures Removal 1.

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Diagnosis with Diagnostic tool 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool). The diagnostic system (Diagnostic tool) provides the following information.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear mode actuator connector (A), loosen the mounting screws and remove the rear mode ac

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0193