| Circuit Diagram |

| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crashpad Lower Panel")
|
| 3. |
Remove the side air vent duct (LH).
|
| 4. |
Remove the lower crash pad switch assembly after loosening the screws.
|
| 5. |
Remove the rheostat switch connector.
|
| 6. |
Check for intensity of new rheostat switch. If the light intensity of
the lamps changes smoothly without any flickering when the rheostat
is turned, it can be assumed that the rheostat is normal.
|
Specifications Specifications [BCW, BCA] Items Blind-Spot Collision Warning (BCW) Blind-Spot Collision- Avoidance Assist (BCA) Rated voltage DC 12V Operating voltage 9V - 16V Operating speed 30 km/h - 255 km/h 60 km/h - 180 km/h Sensible distance 70m Curvature radius Start : More than 100m Start : More than 625m Stop : Less than 70m Stop : Less than 588m Frequency 76 - 77 GHz Numbers 2EA [RCCW, RCCA] Items Rear Cross-Traffic Collision Warning System (RCCW) Rear Cross-Traffic Collision- Avoidance Assist (RCCA) Rated voltage DC 12V Operating voltage 9V ~ 16V Operating speed 0 km/h ~ 10 km/h 0.
Components and components location Components 1. Warning indicator 2. SVM camera Repair procedures Removal 1.
Description Blind-Spot Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).