The Idle Stop and Go (ISG) system automatically and temporarily shuts down the engine when the vehicle is stopped and idling to improve fuel efficiency and reduce exhaust gas emissions. (i.e. red stop light, stop sign, and traffic jam).
The engine is automatically started upon satisfying the starting conditions.
The ISG system is always active, when the engine is running.
Information
When the engine is automatically started by the ISG system, some warning lights (i.e. ABS, ESC, ESC OFF, EPS, and parking brake warning light) may illuminate for a few seconds due to the low battery voltage. However, it does not indicate a malfunction with the ISG system.
Tires Do not use a tire and wheel package with a different size and type from the one originally installed on your vehicle. It can affect the safety and performance of your vehicle, which could lead to steering failure or rollover causing serious injury.
Prerequisite for activation The ISG system operates in the following situations. - The driver's seatbelt is fastened. - The driver's door and the hood are closed.
Repair procedures SReplacement 1. Remove the condenser. (Refer to A/C System - "Condenser") 2. Remove the cap (B) on the bottom of the condenser with an L wrench (A). Tightening torque : 2.
Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →