Hyundai Palisade (LX2): Lubrication System / Oil Filter Body

Hyundai Palisade (LX2) 2020-2026 Service Manual / Engine Mechanical System / Lubrication System / Oil Filter Body

Components and components location

Components

Hyundai Palisade. Components and components location

1. Oil fliter body
2. Gasket

Repair procedures

Removal

•	Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift. (Refer to General Information - "Lift and Support Points")

1.	Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

2.	Drain the engine oil. (Refer to Lubrication System - "Engine Oil")

Remove the oil filter body (A).

Tightening torque :

19.6 - 21.6 N.m (2.0 - 2.2 kgf.m, 14.5 - 15.9 lb.ft)

Hyundai Palisade. Repair procedures

4.	Install in the reverse order of removal

❮Engine Oil

Repair procedures Replacement • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

Oil Pan❯

Components and components location Components 1. Lower oil pan 2. Upper oil pan Repair procedures Removal • Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.

Other information:

Hyundai Palisade (LX2) 2020-2026 Service Manual: Mode Control Actuator

Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →

Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures