Hyundai Palisade (LX2): Fuel Delivery System / Fuel Filter
Repair procedures
| Removal |
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
|
| 2. |
Disconnect the electric pump wiring connector (A), and the fuel sender
connector (B).
|
| 3. |
Remove the fixing clip (A), and then disconnect the feed tube (B).
|
| 4. |
Remove the head assembly (C) after releasing the cushion fixing clip
(D).
|
| 5. |
Remove the reservoir-cup after releasing the fixing hook (A).
|
| 6. |
Remove the fuel pressure regulator fixing clip (A).
|
| 7. |
Remove the fuel pressure regulator (B) from the fuel filter.
|
| 8. |
Remove the pre-filter (B) after releasing the fixing hooks (A).
|
| 9. |
Remove the fuel pump motor (C).
|
| 10. |
Rmove the fuel filter (D).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Description and operation Description The fuel pressure sensor (FPS) is installed on the top of the low pressure fuel pump and measures the pressure in the low pressure fuel line.
Repair procedures Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Heater Unit
Components and components location Component Location 1. Heater unit assembly Components 1. Heater core assembly 2. Heater unit pad 3. Heater lower cover 4. Drain hose 5.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Auto Defogging Actuator
Description and operation Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuato
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Engine Mechanical System
- ISG (Idle Stop and Go) system
- Rear Bumper Cover
- New on site
- Most important about car
