Hyundai Palisade: Light bulbs / Interior Light Bulb Replacement
Map lamp, room lamp, vanity mirror lamp and luggage compartment lamp (Bulb type)
■ Map lamp
■ Room lamp
■ Glove box lamp
■ Vanity mirror lamp
■ Luggage compartment lamp
1. Using a flat-blade screwdriver, gently pry the lens from the interior lamp housing.
WARNING
Prior to working on the Interior Lights, ensure that the "OFF" button is depressed to avoid burning your fingers or receiving an electric shock.
2. Remove the bulb by pulling it straight out.
3. Install a new bulb in the socket.
4. Align the lens tabs with the interior lamp housing notches and snap the lens into place.
NOTICE
Use care not to dirty or damage lens, lens tab, and plastic housings.
Map lamp / Room lamp / Luggage compartment lamp (LED Type)
■ Map lamp
■ Room lamp
■ Luggage compartment lamp
If the LED lamp (1) does not operate, have the system checked by an authorized HYUNDAI dealer.
The LED lamps cannot be replaced as a single unit because it is an integrated unit. The LED lamps has to be replaced with the unit.
A skilled technician should check or repair the LED lamp, for it may damage related parts of the vehicle
License Plate Light Bulb
Replacement
1. Loosen the lens retaining screws
with a cross-tip screwdriver.
2. Using a flat-blade screwdriver,
gently pry the lens cover from the
lamp housing...
Appearance care
Exterior Care
Exterior general caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning
and caution statements that appear
on the label...
Other information:
Hyundai Palisade (LX2) 2020-2025 Service Manual: Description and operation
Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft...
Hyundai Palisade (LX2) 2020-2025 Service Manual: Heater & A/C Control Unit (DATC)
Components and components location Component Connector Pin Function Connector PIN No Pin Function Connector PIN No Pin Function A 1 Battery A 21 IGN2 2 ISG B+ 22 IGN1 3 ILL+ (TAIL) 23 Blower Motor (+) 4 Sensor Ground REF (+5V) 24 Photo Sensor (-)_LEFT 5 Mode Control Actuator Feedback 25 Photo Sensor (-)_RIGHT 6 Temperature Actuator Feedback - Driver 26 Incar Sensor (+) 7 Intake Actuator Feedback 27 Incar Motor (-) 8 Evaporator Temperature Sensor (+) 28 PTC Relay 3 9 Ambient Temperature Sensor (+) 29 PTC Relay 3 10 Mode Control Actuator (Vent) 30 PTC On Signal 11 Mode Control Actuator (Defrost) 31 Detent out (-) 12 Temperature Control Actuator (Cool) - Driver 32 K - Line 13 Temperature Control Actuator (Warm) - Driver 33 P_CAN High 14 Intake Actuator (Fresh Air) 34 P_CAN Low 15 Intake Actuator (Recirculated Air) 35 Mosfet (DRAIN F/B) 16 HTD (Rear Defrost) 36 Mosfet (GATE) 17 Rear Defogging Swich 37 ECV + 18 Clean Signal 38 ECV - 19 Ionizer Diagnosis 39 Sensor Ground 20 ILL - (RHEO) 40 Ground Connector PIN No Pin Function Connector PIN No Pin Function B 1 Temperature Control Actuator Feedback - Passenger B 9 - 2 Temperature Control Actuator (Cool) - Passenger 10 - 3 Temperature Control Actuator (Warm) - Passenger 11 - 4 Defogging Actuator Feedback 12 Defogging Sensor TEMP 5 Defogging Actuator (Open) 13 Defogging Sensor SCK 6 Defogging Actuator (Close) 14 Defogging Sensor Data 7 - 15 - 8 Seat Signal PWM - Driver 16 Ground Repair procedures Self Diagnosis 1...
Categories
- Manuals Home
- 1st Generation Palisade Owners Manual
- 1st Generation Palisade Service Manual
- Fuse/Relay Panel Description
- Rear center seatbelt (3rd row)
- Wireless Cellular Phone Charging System
- New on site
- Most important about car
Manual adjustment
The front seat can be adjusted by using the levers located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel.
