Hyundai Palisade (LX2): Rear View Monitor (RVM) / Description and operation

Hyundai Palisade (LX2) 2020-2026 Service Manual / Advanced Driver Assistance System (ADAS) / Rear View Monitor (RVM) / Description and operation

Description
Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.
Hyundai Palisade. Description and operation   
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rear view mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

    Circuit Diagram

    Removal SVM Rear Camera    • In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Surround View Monitor (SVM) Unit

    Components and components location Components No Connector A 1 ACC 2 LED 3 EXT Ground 4 Y Shield 5 - 6 C-CAN Low 7

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Parking/View Switch

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0094