| Special Service Tools |
|
Tool (Number and name) |
Illustration |
Use |
|
09880 - 4F000 Hog ring clip installer |
|
Hog ring clip installation |
Specifications Items Specification Hood Type Rear hinged, stay rod type Front Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Rear Door Construction Front hinged, frame door construction Regulator system Wire drum type Locking system Pin-fork system Tail Gate Type Front hinged, gas lifter type Seat Belts Front 3 point type with Emergency Locking Retractor (E.
Troubleshooting Symptom Passible Cause Remedy (Refer to page) Water leaks from sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip Adjust Wind noise around sunroof Loose or deformed deflector, gaps in body work Retighten adjust or replace Noise created by moving sunroof lid Foreign particles lodged in guide rail Check drive cable and guide rails for foreign particles Loose guide rails and lid Retighten Motor runs but sunroof does not move or moves only partially Foreign particles lodged in guide rail Adjust or replace Incorrect engagement of motor pinion with drive cable Decrease in motor's clutch slipping force Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc.
Description and operation Description The In-car air temperature sensor is built in the heater & A/C control unit. The sensor consists of a thermistor that measures the inside temperature. The signal decided by the resistance value that changes in accordance with perceived inside temperature, is delivered to heater co
Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of around view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.