Hyundai Palisade (LX2): Body (Interior and Exterior) / Troubleshooting

Hyundai Palisade (LX2) 2020-2026 Service Manual / Body (Interior and Exterior) / Troubleshooting

Troubleshooting
Symptom
Passible Cause
Remedy (Refer to page)
Water leaks from sunroof
 Deteriorated roof lid weatherstrip
 Replace
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
 Adjust
Wind noise around sunroof
Loose or deformed deflector, gaps in body work
 Retighten adjust or replace
Noise created by moving sunroof lid
 Foreign particles lodged in guide rail
 Check drive cable and guide rails for foreign particles
Loose guide rails and lid
 Retighten
Motor runs but sunroof does not move or moves only partially
 Foreign particles lodged in guide rail
 Adjust or replace
Incorrect engagement of motor pinion with drive cable
Decrease in motor's clutch slipping force
Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due to abnormal adjustment of sunroof
Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed) is considered as normal
 Incorrect engagement of motor pinion with drive cable
 Check pinion installation and Re-tighten motor
Worn out or damaged motor pinion bearing
 Replace motor assembly
Worn out or deformed drive cable
 Replace
Door glass fails to operate up and down
 Incorrect window glass installation
 Adjust position
Damaged or faulty regulator arm or regulator
 Correct or replace
Door does not open or close completely
 Incorrect door installation
 Adjust position
Defective door check assembly
 Correct or replace
Door hinge requires grease
 Apply grease
Hood does not open or close completely
 Striker and latch not properly aligned
 Adjust
Incorrectly installed hood
 Adjust
Incorrect hood bumper height
 Adjust
Water leaks through windshield and rear window
 Defective seal
 Fill with sealant
Defective flange
 Correct

    Special Service Tools Tool (Number and name) Illustration Use 09880 - 4F000 Hog ring clip installer Hog ring clip installation

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Heater Core

    Repair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") 3.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Auto Defogging Actuator

    Description and operation Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuato

    Categories

     
    Copyright В© 2026 www.hpalisadelx.com - 0.0192