Hyundai Palisade (LX2): Body Side Molding / Roof Side Molding

Hyundai Palisade (LX2) 2020-2026 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding

Repair procedures

Replacement
Hyundai Palisade. Repair procedures   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Put on gloves to prevent hand injuries.
Hyundai Palisade. Repair procedures   
•
Take care not to scratch the body surface.
1.
Using a flat-tip screwdriver or remover, remove the roof side molding (A).

Hyundai Palisade. Repair procedures
2.
To install, reverse removal procedure.
Hyundai Palisade. Repair procedures   
•
Replace any damaged clips (or pin-type retainers).

    Repair procedures Replacement    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Components and components location Components Location 1. Roof rack assembly Repair procedures Removal    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Troubleshooting

    Troubleshooting    1) After replacing H/UNIT, always check that the system operates properly. 2) If the failure persists after replacing the H/UNIT, do not replace the unit.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Surround View Monitor (SVM) Unit

    Components and components location Components No Connector A 1 ACC 2 LED 3 EXT Ground 4 Y Shield 5 - 6 C-CAN Low 7

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0123