Hyundai Palisade: Rear Bumper / Rear Bumper beam Assembly
Components and components location

1. Rear bumper beam assembly
|
|
Components and components location
Component Location
1. Rear bumper cover
Repair procedures
Replacement
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Other information:
Components and components location
Component Location
1. Front center fascia panel
2. Rear center fascia panel
Repair procedures
Replacement
[Front center facsia panel]
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Panic button
Press and hold the Panic button (4)
for more than one second. The horn
sounds and hazard warning lights
flash for about 30 seconds.
To cancel the panic mode, press any
button on the remote key.
Start-up
For information, refer to the "Key
Ignition Switch" section in chapter 5...
Categories
Seat belt warning light

Driver's seat belt warning
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you place the ignition switch to the
ON position regardless of belt fastening.
At this time, if the seat belt is
not fastened a warning chime will
sound for 6 seconds.
read more