Hyundai Palisade (LX2): Rear Heater / Rear Blower Motor

Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage side trim
(Refer to Body - "Luggage Side Trim ")
3.
Separate the rear blower motor connector (A), loosen the mounting screws and remove the rear blower motor (B).

Hyundai Palisade. Repair procedures

4.
Install in the reverse order of removal.
Hyundai Palisade. Repair procedures   
•
Make sure the connector is connected in properly.

    Repair procedures Replacement 1. Remove the rear heater & A/C unit. (Refer to Rear Heater - "Rear Heater Unit") 2.

    Repair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation

    Description Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0137