Hyundai Palisade (LX2): Smart Cruise Control With Stop & Go System / To Convert to Cruise Control Mode

The driver may choose to switch to use the conventional Cruise Control mode (speed only control function) by following these steps:

1. Push the CRUISE button on the steering wheel to turn the system on. The cruise (Hyundai Palisade. Mode) indicator will illuminate.

2. Push and hold the Vehicle-to- Vehicle Distance button for more than 2 seconds.

3. Choose between "Smart Cruise Control" and "Cruise Control".

When the system is canceled using the CRUISE button or the CRUISE button is used after the engine is turned on, the Smart Cruise Control mode will turn on.

WARNING

When using the conventional Cruise Control mode, you must manually adjust the distance to other vehicles by depressing the brake pedal. The system does not automatically adjust the distance to vehicles in front of you.

    The sensitivity of vehicle speed when following the front vehicle to maintain the set distance can be adjusted. Go to the 'User Settings → Driver Assistance → SCC Reaction → Fast/Normal/Slow' on the LCD display.

    To set Smart Cruise Control speed 1. Push the CRUISE button on the steering wheel to turn the system on. The cruise indicator will illuminate. 2. Accelerate to the desired speed.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation

    Description and Operation Blcok Diagram    • This system monitors the driving situations through the radar and the camera. Thus, for a situation out of the sensing range, the system may not normally operate.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Surround View Monitor (SVM) Camera

    Components and components location Components [Ultra Optical Camera - RH/LH] [Ultra Optical Camera - Front] [Ultra Optical Camera - Rear] Repair procedures Removal    • In case of bad quality or poor

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0203