The remote key will not work if any of the following occur:
If the remote key does not work correctly, open and close the door with the mechanical key. If you have a problem with the remote key contact an authorized HYUNDAI dealer.
If the remote key is in close proximity to your mobile phone, the signal could be blocked by your mobile phone's normal operational signals. This is specifically relevant when the phone is active such as making and receiving calls, text messaging, and/or sending/receiving emails.
When possible, avoid placing the remote key and your mobile phone in the same location such as a pants or jacket pocket in order to avoid interference between the two devices.
Information
This device complies with Part 15 of the FCC rules.
Operation is subject to the following three conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received, including interference that may cause undesired operation.
3.Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.
NOTICE
Keep the remote key away from electromagnetic materials that block electromagnetic waves to the key surface.
Panic button Press and hold the Panic button (4) for more than one second. The horn sounds and hazard warning lights flash for about 30 seconds. To cancel the panic mode, press any button on the remote key.
If the remote key is not working properly, try replacing the battery with a new one. Battery Type: CR2032 To replace the battery: 1.Insert a slim tool into the slot and gently pry open the cover.
Repair procedures Oil Specification 1. The R-134a or R-1234yf system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2.
Components and components location Circuit Diagram Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crashpad Lower Panel") 3.