Hyundai Palisade (LX2): Rear Suspension System / Rear Upper Arm

Repair procedures

Removal
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
Hyundai Palisade. Repair procedures   
•
Be careful not to damage the hub bolts when removing the rear wheel and tire (A).

Hyundai Palisade. Repair procedures

3.
Loosen the bolt & nut then remove the rear upper arm (A) from the rear axle.
Tightening torque:
98.0 - 117.6 N.m (10.0 - 12.0 kgf.m, 72.3 - 86.7 lb-ft)
Hyundai Palisade. Repair procedures   
•
Set up the transmission jack under the lower arm in order to remove it in no-load condition.

Hyundai Palisade. Repair procedures

Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear upper arm or damage and deformation.
3.
Check for all bolts and nut.
Installation
1.
Install in the reverse order of removal.
2.
Check the alignment.
(Refer to Suspension System - "Alingment")

    Components and components location Components 1. Rear shock absorber 2. Dust cover 3. Bumper rubber 4. Insulator assembly 5.

    Repair procedures Removal 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Wireless Power Charging Unit

    Components and positions Components Circuit diagram Circuit Diagram Repair procedures Removal    Handling wireless charging system parts by wet hands may cause electric shock.

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Front Radar Unit

    Specifications Specification Item Specification Power supply (V) 12 Operation voltage (V) 9 - 16 Description and operation Description The smart cruise control unit is installed on the front right-hand side of the chass

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0194