Hyundai Palisade (LX2): Evaporative Emission Control System / Fuel Tank Air Filter
Repair procedures
| Removal |
| 1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the vent hose quick-connector (B), the vapor hose quick-connector
(A) from the canister.
|
| 3. |
Remove the fuel tank air filter assembly after removing the mounting
bolts (C).
|
| 4. |
Remove the fuel tank air filter mounting bolt (A).
|
| 5. |
Remove the clip, and then separate the fuel tank air filter (B) from
the canister after rotating it in the direction of the arrow in the
figure.
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Specifications Specification Item Specification Coil Resistance (Ω) 18.5 - 22.
Description and operation Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Temperature Control Actuator
Description and operation Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation
Description Blind-Spot Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm (visual and auditory).
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Scheduled maintenance services
- How to reset the power liftgate
- Maintenance
- New on site
- Most important about car
