Hyundai Palisade: Body Side Molding / Front Wheel Guard
Repair procedures
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Put on gloves to prevent hand injuries.
|
|
1. |
Remove the front tire.
|
2. |
Loosen the mounting clip, nuts and screws and remove the front wheel
guard (A).

|
3. |
To install, reverse removal procedure.
•
|
Replace any damaged clips (or pin-type retainers).
|
|
|
Components and components location
Components Location
1. Roof rack assembly
Repair procedures
Removal
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Repair procedures
Replacement
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Other information:
Components and components location
Component Location
1. Hood latch release handle
Repair procedures
Replacement
1.
After loosening the hood hinge (A) mounting bolts, remove the hood assembly
(B)...
1. The Safe Exit Assist system is provided
to help prevent the passengers
from opening a door by warning
the passengers when an approaching
vehicle from the rear area is
detected after the vehicle stops.
2. When an approaching vehicle
from the rear area is detected
after the vehicle stops, the rear
door does not unlock even when
the driver tries to unlock the rear
door using the Electronic child
safety lock button...
Categories

The SRS consists of the following
components:
1. Driver's front air bag module
2. Passenger's front air bag module
3. Side air bag modules
4. Curtain air bag modules
5. Retractor pre-tensioner
6. Air bag warning light
7. SRS control module (SRSCM)/
Rollover sensor
8. Front impact sensors
9. Side impact sensors
10.Side pressure sensors
11. Occupant classification system
12. Driver’s knee airbag module
read more