Hyundai Palisade (LX2): Electronic Parking Brake (EPB) / Warning messages

Hyundai Palisade. Warning messages

To release EPB, fasten seatbelt, close door, hood and liftgate

  • If you try to drive with the EPB applied, a warning will sound and a message will appear.
  • If the driver's seat belt is unfastened and the engine hood or liftgate is opened, a warning will sound and a message will appear.
  • If there is a problem with the vehicle, a warning may sound and a message may appear.

If the situation occurs, depress the brake pedal and release EPB by pressing the EPB switch.

WARNING

  • Whenever leaving the vehicle or parking, always come to a complete stop and continue to depress the brake pedal. Shift the gear into the P (Park) position, press the EPB switch, and set the ignition switch to the OFF position. Take the Key with you when exiting the vehicle. Vehicles not fully engaged in P (Park) with the parking brake set are at risk for moving inadvertently and causing injury to yourself or others.
  • NEVER allow anyone who is unfamiliar with the vehicle to touch the EPB switch. If the EPB is released unintentionally, serious injury may occur.
  • Only release the EPB when you are seated inside the vehicle with your foot firmly on the brake pedal.

NOTICE

  • Do not apply the accelerator pedal while the parking brake is engaged. If you depress the accelerator pedal with the EPB engaged, a warning will sound and a message will appear. Damage to the parking brake may occur.
  • Driving with the parking brake on can overheat the braking system and cause premature wear or damage to brake parts. Make sure the EPB is released and the Parking Brake Warning Light is off before driving.

Information

  • A clicking sound may be heard while operating or releasing the EPB. These conditions are normal and indicate that the EPB is functioning properly.
  • When leaving your keys with a parking attendant or assistant, make sure to inform him/her how to operate the EPB.

Hyundai Palisade. Warning messages

AUTO HOLD turning Off! Press brake pedal

When the conversion from Auto Hold to EPB is not working properly a warning will sound and a message will appear.

Hyundai Palisade. Warning messages

Parking brake automatically engaged

If the EPB is applied while Auto Hold is activated, a warning will sound and a message will appear.

    To release the EPB (Electronic Parking Brake): Place the ignition switch in the ON position. Depress and hold the brake pedal. Press the EPB switch.

    This warning light illuminates if the ignition switch is set to the ON position and goes off in approximately 3 seconds if the system is operating normally.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Auto Defogging Sensor

    Description and operation Description The auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intak

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Description and operation

    Description Surround View Monitor (SVM) is the system that allows video monitoring of 360 degrees around the vehicle. The system includes 4 ultra optical camera mounted around the vehicle (front, both sides, rear). The video from these cameras are applied with distortion compensation, time point conversion, and video me

    Categories

     
    Copyright В© 2026 www.hpalisadelx.com - 0.0158