Hyundai Palisade (LX2): Engine And Transaxle Assembly / Engine Room Under Cover

Hyundai Palisade (LX2) 2020-2026 Service Manual / Engine Mechanical System / Engine And Transaxle Assembly / Engine Room Under Cover

Repair procedures

Removal and Installation
Hyundai Palisade. Repair procedures   
•
Be careful not to damage the parts located under the vehicle (floor under cover, fuel filter, fuel tank and canister) when raising the vehicle using the lift.
(Refer to General Information - "Lift and Support Points")
1.
Remove the engine room under cover (A).
Tightening torque:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Hyundai Palisade. Repair procedures
2.
Install in the reverse order of removal.

    Repair procedures Removal and Installation 1. Remove the engine cover (A).    • Lift up the lower end of engine cover, then left and right alternately.

    Components and components location Components 1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting support bracket 4.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Photo Sensor

    Description and operation Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received wh

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Inspection Tolerance Compensation Tolerance compensation compensates for the error margins of around view video that occur due to the installation tolerance when the four cameras that comprise the SVM system are installed. You must carry out tolerance compensation if you do any of the following.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0166