Hyundai Palisade: Downhill Brake Control (DBC) / DBC operation

Downhill Brake Control disabled.
Control vehicle speed

When the DBC system is not working
properly this warning message
will appear on the LCD display and
you will hear a warning sound. If this
occurs, control the vehicle speed by
depressing the brake pedal.
WARNING
Always turn off the DBC on normal
roads. The DBC might activate
inadvertently from the standby
mode when driving through
speed bumps or making sharp
curves.
Information
- Noise or vibration may occur from
the brakes when the DBC is activated.
- The rear stop light comes on when
DBC is activated.
NOTICE
- The DBC may not deactivate on
steep inclines even though the
brake or accelerator pedal is
depressed.
- The DBC system may not always
maintain the vehicle speed at a
certain speed.
- The DBC does not operate when:
- The gear is in P (Park).
- The ESC is activated.
The Downhill Brake Control (DBC)
feature assists the driver to descend
down a steep hill without having to
depress the brake pedal.
The system automatically applies the
brakes to maintain the vehicle speed
below a certain speed and allows the
driver to concentrate on steering the
vehicle down hill...
Trailer Stability Assist system helps
stabilize the vehicle and trailer when
the trailer sways or oscillates. There
are various reasons making the vehicle
sway and oscillate...
Other information:
Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the front glass weatherstrip (B) and roof panel
(A) and adjust it if needed.
Alignment adjustment
Standard value [mm(in...
Key Ignition Switch
WARNING
To reduce the risk of SERIOUS
INJURY or DEATH, take the following
precautions:
NEVER allow children or any
person who is unfamiliar with
the vehicle to touch the ignition
switch or related parts.
Unexpected and sudden vehicle
movement can occur...
Categories
Seat belt warning light

Driver's seat belt warning
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you place the ignition switch to the
ON position regardless of belt fastening.
At this time, if the seat belt is
not fastened a warning chime will
sound for 6 seconds.
read more