Hyundai Palisade: Heating,Ventilation And Air Conditioning / Controller
Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower
motor...
Components and components location
Component
Connector Pin Function
Connector
PIN No
Pin Function
Connector
PIN No
Pin Function
A
1
Battery
A
21
IGN2
2
ISG B+
22
IGN1
3
ILL+ (TAIL)
23
Blower Motor (+)
4
Sensor Ground REF (+5V)
24
Photo Sensor (-)_LEFT
5
Mode Control Actuator Feedback
25
Photo Sensor (-)_RIGHT
6
Temperature Actuator Feedback - Driver
26
Incar Sensor (+)
7
Intake Actuator Feedback
27
Incar Motor (-)
8
Evaporator Temperature Sensor (+)
28
PTC Relay 3
9
Ambient Temperature Sensor (+)
29
PTC Relay 3
10
Mode Control Actuator (Vent)
30
PTC On Signal
11
Mode Control Actuator (Defrost)
31
Detent out (-)
12
Temperature Control Actuator (Cool) - Driver
32
K - Line
13
Temperature Control Actuator (Warm) - Driver
33
P_CAN High
14
Intake Actuator (Fresh Air)
34
P_CAN Low
15
Intake Actuator (Recirculated Air)
35
Mosfet (DRAIN F/B)
16
HTD (Rear Defrost)
36
Mosfet (GATE)
17
Rear Defogging Swich
37
ECV +
18
Clean Signal
38
ECV -
19
Ionizer Diagnosis
39
Sensor Ground
20
ILL - (RHEO)
40
Ground
Connector
PIN No
Pin Function
Connector
PIN No
Pin Function
B
1
Temperature Control Actuator Feedback - Passenger
B
9
-
2
Temperature Control Actuator (Cool) - Passenger
10
-
3
Temperature Control Actuator (Warm) - Passenger
11
-
4
Defogging Actuator Feedback
12
Defogging Sensor TEMP
5
Defogging Actuator (Open)
13
Defogging Sensor SCK
6
Defogging Actuator (Close)
14
Defogging Sensor Data
7
-
15
-
8
Seat Signal PWM - Driver
16
Ground
Repair procedures
Self Diagnosis
1...
Other information:
Tires
Do not use a tire and wheel package
with a different size and type from
the one originally installed on your
vehicle. It can affect the safety and
performance of your vehicle, which
could lead to steering failure or
rollover causing serious injury...
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the overhead console.
3.
Remove the overhead console after disconnect the connector...
Categories

Air bag warning labels, required by
the U.S. National Highway Traffic
Safety Administration (NHTSA), are
attached to alert the driver and passengers
of potential risks of the air
bag system. Be sure to read all of the
information about the air bags that
are installed on your vehicle in this
Owners Manual.
read more