Hyundai Palisade: Roof Trim / Sunvisor
Components and components location
Repair procedures
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Put on gloves to prevent hand injuries.
|
|
• |
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the sunvisor pivot cover (A).
|
2. |
Loosen the mounting screw and seperate the sunvisor (A).
|
3. |
Loosen the mounting screws and remove the retainer (A).
|
4. |
To install, reverse removal procedure.
|
Components
[General Type]
1. Sunvisor
2. Roof trim
3. Assist handle braket
[Sunroof Type]
1...
Components and components location
Component Location
1. Assist handle
Repair procedures
Replacement
•
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components...
Other information:
To fasten your seat belt:
Pull the seat belt out of the retractor
and insert the metal tab (1) into the
buckle (2). There will be an audible
"click" when the tab locks into the
buckle.
You should place the lap belt (1) portion
across your hips and the shoulder
belt (2) portion across your
chest...
..
Categories
Seat belt warning light
Driver's seat belt warning
As a reminder to the driver, the seat
belt warning light will illuminate for
approximately 6 seconds each time
you place the ignition switch to the
ON position regardless of belt fastening.
At this time, if the seat belt is
not fastened a warning chime will
sound for 6 seconds.
read more