Hyundai Palisade: Smart Cruise Control With Stop & Go System / Smart Cruise Control Speed
To set Smart Cruise Control speed
1. Push the CRUISE button on the steering wheel to turn the system on. The cruise indicator will illuminate.
2. Accelerate to the desired speed. The Smart Cruise Control speed can be set as follows:
- 5 – 100 mph (10 - 160 km/h) : when there is no vehicle in front
- 0 – 100 mph (0 - 160 km/h) : when there is a vehicle in front
3. Push the toggle switch down (SET-). The Set Speed and Vehicle-to-Vehicle Distance on the LCD display will illuminate.
4. Release the accelerator pedal. The desired speed will automatically be maintained.
If there is a vehicle in front of you, the speed may decrease to maintain the distance to the vehicle ahead.
On a steep grade, the vehicle may slow down or speed up slightly while going uphill or downhill.
Information
- Vehicle speed may decrease on an upward slope and increase on a downward slope.
- When you are setting the cruise control speed, with a vehicle in front and your vehicle speed is between 0 ~ 20 mph (0 ~ 30 km/h ), the speed will set to 20 mph (30 km/h).
- To increase Smart Cruise Control set speed
- To decrease the Smart Cruise Control set speed
- To temporarily accelerate with the Smart Cruise Control on, Smart Cruise Control set speed will be temporarily canceled when
- To resume Smart Cruise Control set speed, To turn Cruise Control off
To Convert to Cruise Control
Mode
The driver may choose to switch to
use the conventional Cruise Control
mode (speed only control function)
by following these steps:
1. Push the CRUISE button on the
steering wheel to turn the system
on...
To increase Smart Cruise
Control set speed
Follow either of these procedures:
Push the toggle switch up (RES+),
and release it immediately. The
cruising speed will increase by
1 mph (1 km/h) each time you
move the toggle switch up in this
manner...
Other information:
Hyundai Palisade (LX2) 2020-2025 Owner's Manual: Rear lamp, Luggage compartment lamp
Rear lamp Rear Room Lamp (): Press either buttons to turn the room lamp on or off. Luggage compartment lamp • ON () : The luggage compartment lamp stays on at all times. • DOOR () : The luggage compartment lamp comes on when the liftgate is opened...
Hyundai Palisade (LX2) 2020-2025 Owner's Manual: Scheduled maintenance services
Follow Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, you must follow the Maintenance Under Severe Usage Conditions. Repeatedly driving short distances of less than 5 miles (8 km) in normal temperature or less than 10 miles (16 km) in freezing temperature Extensive engine idling or low speed driving for long distances Driving on rough, dusty, muddy, unpaved, graveled or salt- spread roads Driving in areas using salt or other corrosive materials or in very cold weather Driving in heavy dust conditions Driving in heavy traffic area Driving on uphill, downhill, or mountain road Towing a trailer, or using a camper, or roof rack Driving as a patrol car, taxi, other commercial use or vehicle towing Driving over 106 mph (170 km/h) Frequently driving in stop-and-go conditions For additional information or assistance see your authorized HYUNDAI dealer...
Categories
- Manuals Home
- 1st Generation Palisade Owners Manual
- 1st Generation Palisade Service Manual
- Reverse Parking Aid Function
- AC Inverter
- AWD Operation
- New on site
- Most important about car
Seat Belt Warning Light
Seat belt warning light
Driver's seat belt warning
As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you place the ignition switch to the ON position regardless of belt fastening. At this time, if the seat belt is not fastened a warning chime will sound for 6 seconds.
