Hyundai Palisade: Wipers and washers / Rear Window Wiper and Washer

Hyundai Palisade (LX2) 2020-2025 Owner's Manual / Convenient Features of Your Vehicle / Wipers and washers / Rear Window Wiper and Washer

Hyundai Palisade. Rear Window Wiper and Washer

The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to the desired position to operate the rear wiper and washer.

HI – High wiper speed
LO – Low wiper speed
OFF – Off

Hyundai Palisade. Rear Window Wiper and Washer

Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever.

Auto rear wiper

The rear wiper will operate while the vehicle is in reverse with the front wiper ON by selecting the function on the LCD display.

Go to 'User Settings → Convenience → Auto Rear Wiper (in R)'.

    Front Windshield Washers

    In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. The spray and wiper operation will continue until you release the lever...

    Driver Assist System

    ..

    Other information:

    Hyundai Palisade (LX2) 2020-2025 Owner's Manual: System Setting and Operation


    System setting • Setting Blind-Spot Safety function The driver can activate the system by placing the ignition switch to the ON position and by selecting 'User Settings → Driver Assistance → Blind-Spot Safety' - BCA and BCW turn on and are ready to be operated when 'Active Assist' is selected...

    Hyundai Palisade (LX2) 2020-2025 Service Manual: Front Door Module


    Components and components location Component Location 1. Front door module Repair procedures Replacement    • Put on gloves to prevent hand injuries...

    Categories

    Seat Belt Warning Light

    Seat belt warning light

    Hyundai Palisade. Seat Belt Warning Light

    Driver's seat belt warning

    As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you place the ignition switch to the ON position regardless of belt fastening. At this time, if the seat belt is not fastened a warning chime will sound for 6 seconds.

    read more


     
    Copyright © 2025 www.hpalisadelx.com