Hyundai Palisade (LX2): Rear Seats / Walk-in seat (2nd row seat)
To get in or out of the 3rd row seat,
1. Routing the seat belt webbing through the rear seat belt guide clip. After inserting the seat belt, tighten the belt webbing by pulling it up.
2. Push the walk-in switch located on top (1) of the 2nd row seat or the side (2) of the seat bottom cushion.
3. The 2nd row seatback will be folded and push the seat to the farthest forward position.
After getting in or out, slide the 2nd row seat to the farthest rearward position and pull the seatback firmly backward until it clicks into place.
Make sure that the seat is locked in place.
WARNING
Never attempt to adjust while the vehicle is moving or the 2nd row seat is occupied as the seat may suddenly move and cause the passenger on the seat to be injured.
WARNING
- If the walk-in switch does not
work, pull the strap (1) located
on the lower left side of the
seat. Then you can move the
2nd row seat forward.
(7 passenger vehicle
- Left seat : lower right side
- Right seat : lower left side 8 passenger vehicle
- Right seat : lower left side) - Never attempt to pull the strap (1) while the 2nd row seat is occupied as the seat may suddenly move and cause the passenger on the seat to be injured. Use only the strap when the walk-in switch does not work.
Rear seat adjustment Forward and rearward (2nd row seat) To move the seat forward or rearward: 1. Pull the seat slide adjustment lever up and hold it.
The rear seatbacks can be folded to facilitate carrying long items or to increase the luggage capacity of the vehicle. WARNING Never allow passengers to sit on top of the folded down seatback while the vehicle is moving.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: A/C Pressure Transducer
Description and operation Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.
Hyundai Palisade (LX2) 2020-2026 Service Manual: Temperature Control Actuator
Description and operation Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Rain Sensor
- Automatic Transaxle System (A8LF1)
- Electrochromatic Mirror (ECM) with homelink system
- New on site
- Most important about car
