| Troubleshooting |
|
Trouble Symptom |
Probable cause |
Remedy |
|
Vehicle pulls to one side |
Scoring of driveshaft ball joint |
Replace |
|
Wear, rattle or scoring of wheel bearing |
Replace |
|
|
Defective front suspension and steering |
Adjustment or Replace |
|
|
Vibration |
Wear, damage or bending of driveshaft |
Replace |
|
Driveshaft rattle and hub serration |
Replace |
|
|
Wear, rattle or scratching of wheel bearing |
Replace |
|
|
Shimmy |
Defective wheel balance |
Adjustment or Replace |
|
Defective front suspension and steering |
Adjustment or Replace |
|
|
Excessive noise |
Wear, damage or bending of driveshaft |
Replace |
|
Rattle of driveshaft and worn hub splines |
Replace |
|
|
Wear, rattle or scoring of wheel bearing |
Replace |
|
|
Loose hub nut |
Adjustment or Replace |
|
|
Defective front suspension and steering |
Adjustment or Replace |
Special Service Tools Tool(Number and Name) Illustration Use 09495-3K000 Band installer Installation of ear type boot band.
Repair procedures Oil Specification 1. The R-134a or R-1234yf system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2.
Description and operation Description The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.