Hyundai Palisade (LX2): What to Do in an Emergency / Tire Pressure Monitoring System (TPMS)
(1) Low Tire Pressure / TPMS Malfunction Indicator Lamp
(2) Low Tire Pressure / Tire Pressure Monitor / TPMS Malfunction Display (shown on the cluster LCD display)
- Check Tire Pressure
- Tire Pressure Monitoring System
- Low Tire Pressure Telltale
- TPMS Malfunction Indicator
- Changing a Tire with TPMS
If your temperature gage indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine may be overheating. If this happens, you should: 1.
You can check the tire pressure in the Assist mode on the cluster. Refer to the "LCD Display Mode" section in chapter 3. A "Drive to display" message will appear for the first few minutes of driving after initial engine start up.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Mode Control Actuator
Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →
Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear mode actuator connector (A), loosen the mounting screws and remove the rear mode ac
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Engine Mechanical System
- Automatic Transaxle Fluid (ATF)
- Rain Sensor
- New on site
- Most important about car
