Hyundai Palisade (LX2): Restraint / Repair procedures

Hyundai Palisade (LX2) 2020-2026 Service Manual / Restraint / Repair procedures

Component Replacement after Deployment
Hyundai Palisade. Repair procedures   
•
Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag(s)
–
Seat belt pretensioner(s)
–
Front impact sensors
–
SRS wiring harnesses
–
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag(s)
–
Side impact sensor(s) for the deployed side(s)
–
SRS wiring harnesses
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
–
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

    Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the warning lamp for a LED lamp check.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Specifications

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Troubleshooting

    Troubleshooting    1) After replacing H/UNIT, always check that the system operates properly. 2) If the failure persists after replacing the H/UNIT, do not replace the unit.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0152