| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Connect positive (+) and negative (-) battery cables to terminals 3
and 2 respectively to see that the washer motor runs and water is pumped.
|
| 4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Repair procedures Inspection 1. Check for continuity between the terminals in each switch position as shown below.
Repair procedures Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed.