Hyundai Palisade (LX2): Lighting System / Hazard Lamp Switch
Repair procedures
| Removal |
| 1. |
Disconnct the negative (-) battery terminal.
|
| 2. |
Remove the audio/AVN keyboard assembly.
(Refer to Audio - "Audio Keyboard Assembly")
(Refer to AVN System - "AVN Keyboard Assembly")
|
| Installation |
| 1. |
Install the audio/AVN keyboard assembly.
|
| 2. |
Connect the negative (-) battery terminal.
|
Schematic diagrams Circuit Diagram Repair procedures Inspection 1. Remove the overhead console lamp connector (A) then check for continuity between terminals.
Components and components location Components Repair procedures Inspection Rheostat Switch 1. Disconnect the negative (-) battery terminal.
Other information:
Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage side trim (Refer to Body - "Luggage Side Trim ") 3. Separate the rear mode actuator connector (A), loosen the mounting screws and remove the rear mode ac
Hyundai Palisade (LX2) 2020-2026 Service Manual: Troubleshooting
Troubleshooting 1) After replacing H/UNIT, always check that the system operates properly. 2) If the failure persists after replacing the H/UNIT, do not replace the unit.
Categories
- Manuals Home
- Hyundai Palisade Owners Manual
- Hyundai Palisade Service Manual
- Lift and Support Points
- Electrochromatic Mirror (ECM) with homelink system
- Engine Mechanical System
- New on site
- Most important about car
