Hyundai Palisade (LX2): Ignition System / Description and operation

Hyundai Palisade (LX2) 2020-2026 Service Manual / Engine Electrical System / Ignition System / Description and operation

Description
Ignition timing is controlled by the electronic control ignition timing system.
The standard reference ignition timing data for the engine operating conditions are pre-programmed in the memory of the ECM (Engine Control Module).
The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.
The ignition coil is activated, and timing is controlled.

    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC.

    Other information:

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level →

    Hyundai Palisade (LX2) 2020-2026 Service Manual: Repair procedures

    Removal SVM Rear Camera    • In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

    Categories

     
    Copyright © 2026 www.hpalisadelx.com - 0.0159